Thursday 17 November 2011

Trixie's new collar

I decided I wanted to make Trixie a new collar and started pulling apart old ones to see if I could actually sew a nice collar before buying supplies.

I am very happy with it so I also made her a matching lead. I decided to embroider her name and phone numbers on the ribbon for this collar as well since she always loses her tags anyway. Now I just need to hope she doesn't lose her collar as well!

It is nice that Trixie can have a collar different to all of her doggy friends. Next is buying supplies to make collars for the cats...



Friday 4 November 2011

Ribbon dog tag

We had the need to buy Trixie a zappy collar after receiving a threatening letter about her barking! Not that she barks much because I have her inside - but better safe than sorry. I am home most of the time so she doesn't need to wear it very often, but we have a wedding to go to next weekend and she will be wearing her zappy collar. Because the collar I bought works through vibrations I can't have any tags hanging from her collar or have her wear her normal collar. I don't want to leave her alone without a name tag in case she escapes or gets let out, even though she is microchipped.



Enter Trixie's new ribbon tag...

What you will need:
  • A ribbon either the same width or smaller than your collar
  • A candle or lighter
  • Needle and thread (I used regular sewing machine thread but you can use embroidery thread)
  • Scissors
  • Marker
  • Lamp or lightbox
  • Sticky tape
  • Optional: Name and phone number printed off your computer
  • Optional: Sewing machine
I chose to print off Trixie's name and my mobile number only since I won't be home anyway. I did it in all different sizes then just cut out the size I chose. You can just write directly onto your ribbon if you prefer.

You will need to either write or trace your text onto the ribbon. I don't have a lightbox so I just used my lamp by taping the piece of paper onto the lamp. Now you will need to line up your ribbon and tape it down as well. I just used a texta to trace the text lightly onto the ribbon as a guide for my embroidery.





Now you need to start your embroidery. I used a simple backstitch with a doubled over piece of thread knotted at the end. For added security, at the end of each letter I tie a knot just in case the thread gets caught on something - saves me redoing the whole tag again!




After you have finished you need to trim the ends and melt them using your candle - this will stop the ribbon fraying. Just do it quickly and make sure your ribbon is made of polyester otherwise it will catch on fire! At this point you can either fold the edges over and pin the ribbon onto your collar or just leave the ends unfolded as I have done.


I sewed my ribbon to the collar using my sewing machine, but I have also done it by hand before, it just takes longer. I used black thread so it is easier for me to unpick later on if I need to.




Because Trixie is still a puppy this collar is far too big for her, but I didn't want to cut the webbing in case I want to sell it or use it on a bigger dog. So I made a couple of those elastic collar keepers I showed you previously for the cats collars.


Now it is ready for the poor little puppy to wear next weekend!

You can easily do the same thing for cat collars as well. It saves dogs and cats getting their tags caught and losing them all the time.